Our range of GT cranes are designed specifically for the injection molding industry. Designed for presses from 50T to 5000T. Our hand control cranes are designed based on the specific issues of distance between presses, tie bar spacings, height of machines and limitations of ceiling height in mold storage rooms. Our designers understand the industry and have top load cranes that can fit between tie-bar and ceiling and side load cranes that insert through the operator door if gantry robots and auxiliaries on top of the press are an issue. No need for a forklift; one operator can move the mold and install it into the press using the wireless hand-held pendant control for the crane. The machines can sufficiently increase your productivity as you are not limited by crane locations, do not need to tie up a forklift and forklift driver in addition to your operator and can move freely between mold storage and molding area. The cranes also improve your safety as they are designed based on your press sizes and individual mold sizes. When was the last time they asked you those specifics when you ordered a forklift?!
Check out the video below to see these amazing cranes in action: